im in the process of changing out my fuel injectors and on the the o rings sliped off the old injector as i was taking it off and fell down into im assuming the cylinder. do i need to get this out? being rubber could i run the engine and let it melt?

 

should have no permanent effect, even if it got stuck in the valve seat it would not last long there.

 

so it should be fine just to let it run?

 

kinda hard for the oring to fall in the hole more than likely its on the motor keep working

 

im sure its in there.. i dont wanna take any chances either

 

flash light small wire start gigging

 

The injector o-ring is slightly bigger than the hole in the manifold so I'd be pretty surprised if it actually went into the engine.

 

now the secrets out

 

they were old and crumbling... they have never been changed till today. PO did not maintenance

 

haha

 

x2 not trying to be smart but its either this pull intake or run it