I found a 1993 cherokee country and was wondering if parts like the brake lines and anything else would work on my 1989cherokee. Thanks in advance.

 

alot of parts will fit from 93 to 89,interior body some under hood things and suspension,motor tranny and transfer case are questionable

 

I am trying to figure out if it is worth getting.That is my issue. I believe I can use tbe cooling system. Time for more research!

 

The cooling system most certainly won't be the same. The Renix uses a pressure bottle and the Antichrysler has a traditional radiator cap and overflow bottle

 

The cooling system arent the same but the parts can be swapped over. I actually suggest if you do buy it to swap over to open cooling system. Makes it a ton lot easier to bleed of the air. I did it on mines and have never had a problem. Tcase and tranny are going to be different though. Output shaft are 21 spline on the trans. The 93 has a 23 output shaft. The front axle also wont have a vac disconnect which IMo is more of a good thing on the 93. None of the engine sensors etc will swap over cept the MAP I believe. The renix system is a lot different from the chryco HO 4.0

Non compatible parts:
-engine sensors
-intake
-throttle body
-transmission
-tcase
-exhaust manifold
-alt (I think may be an upgrade if you do research on it)

compatible parts (same):
-MAP sensor
-interior parts (panels, dash, steering wheel, etc)
-driveshafts
-rear axle if D35
-brake lines
-most of the hoses etc
-water pump
-power steering pump

compatible parts that will be an upgrade:
-rear axle if its a chryco 8.25
-front D30 (non vacuum)
-radiator (cooling system to convert to open style)