Hey all


OK so I need a little guidance on a part or two....
I've managed to source the tie rod ends I need but need to know possible part numbers or names for the drag link ie is it a one piece or can I replace the bush at the wheel end as well as at the pitman arm end...? Also I need to know the name or part number of the end that goes into the pitman arm... All the ends are shot and I've got to get an inspection done.. Hope that makes sense.

Any help is welcome and appreciated.

Thanks in advance

Steve.

 

Try www.quadratec.com you'll get all the parts you could ever need

 

When you start a thread for help, tell us what year your Jeep is......

 

In my haste for knowledge I forgot to part with that info....

 

Sorry folks its a Cherokee XJ 1998 4.0L

 

Save this...

 

Tie Rod Ends .....

 

For your Tie Rod setup order a set for a mid-90's V-8 Grand Cherokee direct bolt-in and much stronger than the stock one. You will get the long tie rod & end with a short one and a sleeve all that's needed. I bought the better rods from AutoZone not the cheapies for under $100 out the door.

Never just replace when you can upgrade for so little more.

 

Thanks all.....