Need help I have replaced the brake booster,the master cylinder. front caliapers and lines. replaced the back brakes and drums everything is new front to back.have bleed the system like 6 times and still cant get any pressure.the only thing haven't replaced yet is purporting valve.could this be why I am not getting any brakes? it is non ABS.

 

You get no pressure but you bled the lines properly? Im a bit confused. Does your pedal go to the floor? Is there any resistance whatsoever when the car is off?

 

Did ya bench bleed the master cylinder before you installed it?

 

I have nothing I bleed them in order rr to lft front lft rear to rt front. yeah I bench bled it.

 

every time one of these posts come up, i have to ask, did you put the calipers on the correct sides? bleeder valve above the brake line?
9 times out of 10, they were installed wrong. easy to do, so don't feel embarrassed.

otherwise, you may have to adjust the pedal rod from the booster to the master.

 

I work at a dealership as a tech and I've seen a guy do that before. Nobody told him, just kept telling him to bleed it

 

Should be RR/LR/RF/LF
Did you adjust the rear
shoes up?

 

the wrong side? there aint no left and right there made the same and the same part# guess mine is made different than yours.my old calipers had plastic pistons and the new ones are steel that don't matter though. and yeah they have been bleed right.

 

yeah

 

yes there is a right and a left specific side. look again.