Need to remove the parking brake cable from the backing plate
#1
Member
Thread Starter
Join Date: May 2018
Posts: 233
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee (XJ)
Need to remove the parking brake cable from the backing plate
I think this is the right forum, since it's still stock stuff, even though my need to do it is because of a conversion.
How do I remove the parking brake cable from the backing plate? Everything that holds it together is so rusted I can't make heads or tails of anything. But after taking everything apart, the cable itself is fine. I already have new hard lines, so I'm not trying to salvage those.
How do I remove the parking brake cable from the backing plate? Everything that holds it together is so rusted I can't make heads or tails of anything. But after taking everything apart, the cable itself is fine. I already have new hard lines, so I'm not trying to salvage those.
#2
CF Veteran
Join Date: Oct 2013
Location: Greenville, SC
Posts: 5,920
Likes: 0
Received 190 Likes
on
165 Posts
Year: 1999
Model: Cherokee(XJ)
Engine: 4.0
There's tabs on the end of the parking brake cable that are spread you need to squeeze them together and pull the cable through the backing plate.
#3
Member
Thread Starter
Join Date: May 2018
Posts: 233
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee (XJ)
Thanks. That backing plate has seen better days.
#4
Senior Member
Join Date: Dec 2018
Location: Harrisburg,Pa.
Posts: 682
Received 365 Likes
on
262 Posts
Year: 1999
Model: Cherokee (XJ)
Engine: 4.0L
If it gives you a rough time you can use a small worm gear hose clamp to get it started out the hole then just loosen it up after it's partially through..
Thread
Thread Starter
Forum
Replies
Last Post
Colorado_XJ_Guy
Modified XJ Cherokee Tech
10
06-03-2019 09:03 PM
Fredo57
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
9
05-23-2009 10:36 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)