I need help figuring out why my passenger side window will not roll up. all the other windows work from driver side controlls, except for the passenger window....oh and the doors will unlock, but they wont lock. I need to figure this out before it rains!

 

wow this sucks...its gonna pour tomorrow and my window wont roll up

 

I am a window tinter and run into malfunction windows often. Sometimes you can hold the switch in the up position and bang on the door panel a little. Does it make any noise at all? Motor spinning? Clicking?

 

Sounds like you ought to be covering that window with some plastic ASAP. Electrical problems are the worst. First thing I'd try is pull the switch and clean all the terminals with electric parts cleaner. If that doesn't work, try and kick and swear at it for a few minutes. If that doesn't work, give up and buy lots of trash bags.

 

i swore at it enough already...ill try to hit it a few time...it sucks cause its worked fine for like a year or 2 the only problem was the lock out switch

 

ok so after a few quick jabs and a few "Persuasive" words i got it to roll up...yay! anybody know what i can do to fix this?

 

Bad connection or a bad motor.

 

i wish they were all crank windows

 

Have you ever installed new speakers in your doors? The pushrod may just be not aligned anymore

 

pull the door handle off on the inside i bet your connection is loose, my window in my 87 did this it would roll down, but wouldn't roll up and it would only roll down on the passenger side pulled the handle and the connection was only half on. I pushed down the little tangs that are on the top and botton of the door handle and put the connector back on and haven't had a problem since.

 

yes I put new speakers in close to a year ago....I think they suck worse than the stock ones.

 

any possibility it could be the switch