Ok guys so I scored a metal tank skid a few weeks ago at the JY off a 89 xj. I tried to install it today. Had a few problems. Won't go over crappy plastic skid. Dumb question, but I assume I need to remove the plastic skid?
Next question, the holes in the skid and unibody line up, but theres no thread. What's best way to attach skid? I was thinking of welding a nut to the frame, but I also ordered a JCR rear bumper and it has tie-in brackets like so:
How do I attach the tank skid?
Next question, the holes in the skid and unibody line up, but theres no thread. What's best way to attach skid? I was thinking of welding a nut to the frame, but I also ordered a JCR rear bumper and it has tie-in brackets like so:
How do I attach the tank skid?
CF Veteran
You need to get the piece that goes in the frame that has nuts welded to it. You will have to pull a bumper to get it out.
CF Veteran
Quote:
These pieces. You can try to buy them or make them. Originally Posted by 4.3L XJ
You need to get the piece that goes in the frame that has nuts welded to it. You will have to pull a bumper to get it out.
CF Veteran
they have them at the dealership. i just bought them to mount my skidplate. wish i had a damn welder
Thanks for the info guys. Those strips would be alot better. I know if I weld those nuts to the frame, it's going to cause problems w/those tie in brackets.
So once the rear bumper is removed, you slide those brackets in? Do they have to be welded to the frame somehow?
jonnyb, how much were those strips? I only paid $10 for the gas tank skid
So once the rear bumper is removed, you slide those brackets in? Do they have to be welded to the frame somehow?
jonnyb, how much were those strips? I only paid $10 for the gas tank skid
Ok thanks. I'll pull my rear bumper off today. Maybe I'll weld the nuts to the inside or just place some in there.
As far as the plastic skid.. that has to be removed right? I can't remember if the xj I pulled the metal one from, had anything there or not.
As far as the plastic skid.. that has to be removed right? I can't remember if the xj I pulled the metal one from, had anything there or not.
Senior Member
i just put a factory skid on my 96 and i left the plastic one on i did have to trim the side of the plastic off flush with the tank because the skid was hitting them
Quote:
How did you bolt the metal skid up? With those nut strips?Originally Posted by jd4x426
i just put a factory skid on my 96 and i left the plastic one on i did have to trim the side of the plastic off flush with the tank because the skid was hitting them
Senior Member
yes i have a hitch on mine already so i had them already just had to take out the bolts and put it on but all you have to do is get those nutstrips good luck
Ok guys, so I got my metal tank skid installed. 
I trimmed the plastic all off the sides, and the skid feet mouted to the frame. I just went to Ace and bought 4, 3/8" self tappers and drilled new holes in the skid and frame. I may add another screw on each side after my bumper is in. Was not that hard to do.
Thanks for all the help.
I trimmed the plastic all off the sides, and the skid feet mouted to the frame. I just went to Ace and bought 4, 3/8" self tappers and drilled new holes in the skid and frame. I may add another screw on each side after my bumper is in. Was not that hard to do.
Thanks for all the help.