How to take off the Driver's Side Fender?
#1
Seasoned Member
Thread Starter
How to take off the Driver's Side Fender?
My Brother and I went to the Junkyard today and ran out of daylight before we could figure out how to get a drivers side fender off of an 89 Cherokee Laredo. We took out the star head bolts from the top, front and back-(had to open the drivers door to get to them). It still seemed kinda stuck. Also took out the bottom two bolts that are right below the trim piece. The header panel was off already btw. What else holds the fender on?
#2
Seasoned Member
Join Date: Oct 2010
Location: East Lake, NC
Posts: 272
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1987
Model: Cherokee
Engine: 4.0
Might be some inside the door jamb. I don't know specifically for Cherokees, I've never taken one off, but it's common for there to be bolts in the jamb.
#3
Seasoned Member
Thread Starter
#5
CF Veteran
Join Date: Mar 2010
Location: wilkes barre PA.
Posts: 1,200
Likes: 0
Received 0 Likes
on
0 Posts
Year: 96
Model: Cherokee
Engine: 6 cylinder
There are 5 under the hood. 2 in the door jab. Last take off your grill there are two screws that hold the fender to the front clip, take the nuts off the bolts and slide the fender out.
#7
Seasoned Member
Thread Starter
Trending Topics
#8
CF Veteran
Join Date: Jun 2010
Location: Flint/Asheville
Posts: 2,501
Likes: 0
Received 4 Likes
on
4 Posts
Year: 1995
Model: Cherokee
Engine: 4.0 HO
yup, its under the inner fender plastic crap and shares a nut with the fender flare, on pre 97's.
can you get the fender to move around but come off the jeep all the way?
can you get the fender to move around but come off the jeep all the way?
#9
Seasoned Member
Thread Starter
#10
CF Veteran
Join Date: Jun 2010
Location: Flint/Asheville
Posts: 2,501
Likes: 0
Received 4 Likes
on
4 Posts
Year: 1995
Model: Cherokee
Engine: 4.0 HO
yea its that bracket then. You can peel back the inner fender at the top of the wheel well and should be able to feel it, just remove the one nut to the flare and it will come off
#11
CF Veteran
Join Date: Jun 2010
Location: Flint/Asheville
Posts: 2,501
Likes: 0
Received 4 Likes
on
4 Posts
Year: 1995
Model: Cherokee
Engine: 4.0 HO
Oh theres also one at the bottom in the front of the fender, in the front of the wheel well. It bolts to a little bracket that supports the air dam and lower corner of the fender
#12
Seasoned Member
Thread Starter
I did see that one, but failed to mention in my op. Thank you so much for the help. As well as everybody else. This is just what I needed, fast answer to a question.
Thread
Thread Starter
Forum
Replies
Last Post
Sandyman
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
5
09-05-2015 07:56 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)