High idle
Thread Starter
Newbie
Joined: Mar 2011
Posts: 20
Likes: 0
From: Peoria, AZ
Year: 1998
Model: Cherokee
Engine: 4.0
High idle
I can't find this specific issue anywhere, hopefully somebody can lead me in the right direction. So I have a high idle issue and sometimes a hard start issue. The high idle happens intermittently and goes no more than 1200 rpm. I cannot pinpoint anytime it does it but it seems to happen more after it is warm. If I shut the engine off then start back up the high idle goes away. The hard start happens intermittently as well. It has a new fuel pump and spark plugs/wires. I also did the PCM reset according to another post on forum. Thanks for the help.
Senior Member
Joined: Mar 2010
Posts: 855
Likes: 1
From: Southern California
Year: 1989 Laredo
Model: Cherokee
Engine: 4.0 Inline 6 Renix
Yea I have the same issue,
I have a new TPS & I just cleaned my IAC
Maybe I need a NEW IAC or I was starting to look at the MAP Sensor....
Not sure, hope that helps...
I have a new TPS & I just cleaned my IAC
Maybe I need a NEW IAC or I was starting to look at the MAP Sensor....
Not sure, hope that helps...
Thread Starter
Newbie
Joined: Mar 2011
Posts: 20
Likes: 0
From: Peoria, AZ
Year: 1998
Model: Cherokee
Engine: 4.0
Originally Posted by 99 Purple XJ
When was the last time the IAC was cleaned
Sent from my iPhone using CherokeeFM
CF Veteran
Joined: Oct 2010
Posts: 1,889
Likes: 2
From: Long Island N.Y.
Year: 1999
Model: Cherokee
Engine: I6 4.0
Remove it form the throttle body and spray it with carb cleaner and scrub it lightly with a brush and re install it if that doesn't work buy a new one read http://www.jeepforum.com/forum/f9/ia...on-489089/this
CF Veteran
Joined: Nov 2010
Posts: 5,841
Likes: 117
From: In the middle of Minnesota!
Year: 1999
Model: Cherokee
Engine: 4.0
Start here>
--------------------
The Idle Air Control (IAC) is mounted on the back of the throttle body. The valve controls the idle speed of the engine by controlling the amount of air flowing through the air control passage. It consists of a stepper motor that moves a pintle shaped plunger in and out of the air control passage. When the valve plunger is moved in, the air control passage flows more air which raises the idle speed. When the valve plunger is moved out, the air control passage flows less air which lowers the idle speed. Over time and miles, the IAC can get carboned up which can have an adverse affect on idle quality. Cleaning the IAC may restore proper function and is an easy procedure to perform and good preventive maintenance so it is never a bad idea.
CLEANING THE JEEP 4.0 IDLE AIR CONTROL
Remove the air filter cover, associated hoses and the rubber boot that goes from the air filter cover to the throttle body. Remove the IAC with a torx driver (2 bolts; one can be kind of hard to get to)
“Gently” wiggle out the IAC from the throttle body. Gasket on the IAC can be re-used if it is not damaged
Clean the IAC with a spray can of throttle body cleaner; inexpensive and available at any place that sells auto parts. Throttle body cleaner is recommended rather than carburetor cleaner as it is less harsh, safe for throttle body coatings and is best for this task. Use cleaner, a rag and a toothbrush and or Q-Tips. Be gentle; don’t twist or pull on the pintle that protrudes from the IAC as it is fragile and you could damage it.
Thoroughly spray clean and flush where the IAC seats in the throttle body with the same spray cleaner
It is also a good idea to clean the entire throttle body itself, the butterfly valve inside of the throttle body and all associated linkage as long as you have things disassembled
Reinstall IAC and check idle quality
--------------------
The Idle Air Control (IAC) is mounted on the back of the throttle body. The valve controls the idle speed of the engine by controlling the amount of air flowing through the air control passage. It consists of a stepper motor that moves a pintle shaped plunger in and out of the air control passage. When the valve plunger is moved in, the air control passage flows more air which raises the idle speed. When the valve plunger is moved out, the air control passage flows less air which lowers the idle speed. Over time and miles, the IAC can get carboned up which can have an adverse affect on idle quality. Cleaning the IAC may restore proper function and is an easy procedure to perform and good preventive maintenance so it is never a bad idea.
CLEANING THE JEEP 4.0 IDLE AIR CONTROL
Remove the air filter cover, associated hoses and the rubber boot that goes from the air filter cover to the throttle body. Remove the IAC with a torx driver (2 bolts; one can be kind of hard to get to)
“Gently” wiggle out the IAC from the throttle body. Gasket on the IAC can be re-used if it is not damaged
Clean the IAC with a spray can of throttle body cleaner; inexpensive and available at any place that sells auto parts. Throttle body cleaner is recommended rather than carburetor cleaner as it is less harsh, safe for throttle body coatings and is best for this task. Use cleaner, a rag and a toothbrush and or Q-Tips. Be gentle; don’t twist or pull on the pintle that protrudes from the IAC as it is fragile and you could damage it.
Thoroughly spray clean and flush where the IAC seats in the throttle body with the same spray cleaner
It is also a good idea to clean the entire throttle body itself, the butterfly valve inside of the throttle body and all associated linkage as long as you have things disassembled
Reinstall IAC and check idle quality
Trending Topics
Thread Starter
Newbie
Joined: Mar 2011
Posts: 20
Likes: 0
From: Peoria, AZ
Year: 1998
Model: Cherokee
Engine: 4.0
Originally Posted by tjwalker
Start here>
--------------------
The Idle Air Control (IAC) is mounted on the back of the throttle body. The valve controls the idle speed of the engine by controlling the amount of air flowing through the air control passage. It consists of a stepper motor that moves a pintle shaped plunger in and out of the air control passage. When the valve plunger is moved in, the air control passage flows more air which raises the idle speed. When the valve plunger is moved out, the air control passage flows less air which lowers the idle speed. Over time and miles, the IAC can get carboned up which can have an adverse affect on idle quality. Cleaning the IAC may restore proper function and is an easy procedure to perform and good preventive maintenance so it is never a bad idea.
CLEANING THE JEEP 4.0 IDLE AIR CONTROL
Remove the air filter cover, associated hoses and the rubber boot that goes from the air filter cover to the throttle body. Remove the IAC with a torx driver (2 bolts; one can be kind of hard to get to)
"Gently" wiggle out the IAC from the throttle body. Gasket on the IAC can be re-used if it is not damaged
Clean the IAC with a spray can of throttle body cleaner; inexpensive and available at any place that sells auto parts. Throttle body cleaner is recommended rather than carburetor cleaner as it is less harsh, safe for throttle body coatings and is best for this task. Use cleaner, a rag and a toothbrush and or Q-Tips. Be gentle; don't twist or pull on the pintle that protrudes from the IAC as it is fragile and you could damage it.
Thoroughly spray clean and flush where the IAC seats in the throttle body with the same spray cleaner
It is also a good idea to clean the entire throttle body itself, the butterfly valve inside of the throttle body and all associated linkage as long as you have things disassembled
Reinstall IAC and check idle quality
--------------------
The Idle Air Control (IAC) is mounted on the back of the throttle body. The valve controls the idle speed of the engine by controlling the amount of air flowing through the air control passage. It consists of a stepper motor that moves a pintle shaped plunger in and out of the air control passage. When the valve plunger is moved in, the air control passage flows more air which raises the idle speed. When the valve plunger is moved out, the air control passage flows less air which lowers the idle speed. Over time and miles, the IAC can get carboned up which can have an adverse affect on idle quality. Cleaning the IAC may restore proper function and is an easy procedure to perform and good preventive maintenance so it is never a bad idea.
CLEANING THE JEEP 4.0 IDLE AIR CONTROL
Remove the air filter cover, associated hoses and the rubber boot that goes from the air filter cover to the throttle body. Remove the IAC with a torx driver (2 bolts; one can be kind of hard to get to)
"Gently" wiggle out the IAC from the throttle body. Gasket on the IAC can be re-used if it is not damaged
Clean the IAC with a spray can of throttle body cleaner; inexpensive and available at any place that sells auto parts. Throttle body cleaner is recommended rather than carburetor cleaner as it is less harsh, safe for throttle body coatings and is best for this task. Use cleaner, a rag and a toothbrush and or Q-Tips. Be gentle; don't twist or pull on the pintle that protrudes from the IAC as it is fragile and you could damage it.
Thoroughly spray clean and flush where the IAC seats in the throttle body with the same spray cleaner
It is also a good idea to clean the entire throttle body itself, the butterfly valve inside of the throttle body and all associated linkage as long as you have things disassembled
Reinstall IAC and check idle quality
Sent from my iPhone using CherokeeFM
Thread Starter
Newbie
Joined: Mar 2011
Posts: 20
Likes: 0
From: Peoria, AZ
Year: 1998
Model: Cherokee
Engine: 4.0
Originally Posted by Ender
Let us know if that works for you because I did that and my issue still remains. Good Luck!
Sent from my iPhone using CherokeeFM
Last edited by westvalleyxj; May 12, 2011 at 02:50 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Programbo
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
23
May 23, 2024 07:20 AM
Zerocyde
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
45
Jun 29, 2022 05:51 PM
bufbarnaby
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
11
Sep 14, 2015 09:14 AM
WolfeMan
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
Sep 14, 2015 06:42 AM
15XJ
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
7
Sep 10, 2015 11:17 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)