i dont have one big enough thats what i always used on my ratchet til i got a air compressor.

my stepdad got an 18inch pipe wrench hopefully i can get it lose now that i got the steering off the pitman arm.

 

put the pipe wrecnh on the handle of the cresent your almost to the fun part

 

got the nut lose but now the cheap *** oem puller drop bolts that tight the to the pitman arm broke and shot across the garage. going to TSC to get come grade 8 bolts that are long enough and one break into two.

 

you need to tap the center bolt when remove ing the arm tighten alittle ttap some tighten a little tighten some youll get it

 

yeah but i kinda cant tighten it onto the pitman arm cus the two bolts broke.

 

after you get the bolt auto zone gave you the wrong puller if it has bolt law suite

 

i got the heavy duty puller. luckily my mom was at work so her surburban wasnt in the garage or else it would have a nice ding from the flying bolt.

http://contentinfo.autozone.com/znet...27170/image/2/


exact one i got.

 

this one i cant get the pic to post but its one piece with a bolt thru the center no side bolts to break

 

these are safer

 

alright will if i cant get it off with the one i have ill try that one, the guy at autzone said people were having problems with that one so i rented the $90 and not having good luck with it.

 

:hea dbang:tapping is the secret the one you have will do it just you gotta work it told you the fun part was yet to come there a ***** its not just yours

 

from what ive read on forums they always are difficult to deal with. hopefully i will have the jeep all finished by tomorrow with the new 32s i have mounted and balanced that i havent been able to put on her yet. but i might have to take them off cus i need to schedule and alignment so i dont run through the thread.

 

get the arm off first them ill help you with that ok

 

alright sounds good man. thanks!

 

all you need is atape measure for the toe and you can get good enough untill your aligment