oh yeah, born and raised 801 lol. i'll check it out, thanks for the heads up.

 

can someone post the actual part # for the O- rings from NAPA, Autozone, Carqwest, etc. that they ended up getting?

 

cant wait to hear gas reports!

 

OK, Im going to do this for sure. I just want to clarify some stuff...

I read thru the post up with the picture describing the different injectors from dodge and ford and what you need for a cherokee...

Im going to go to the jy tomorrow and find what I want... I need to get 6 injectors out of a dohc neon or stratus or caravan. Do they say the model type on them? How can I tell if they are good? Any special tools?

Thank you in advance. Im pretty stoked on this

 

I got mine yesterday out of a 2.4L engine Stratus. (2 of em)

 

page 2 dude.

 

last 3 numbers on injector need to be 703. use a 9v batt and gator clip jumpers and touch contacts on injector. they should click when they get power. no special tool really needed. use anything to pop off clips. GL.

 

put my 703's in about 2 weeks ago. ive gotten 1.5 mpg better in last 2 tanks. havent been on highway yet. looking for an excuse fora road trip soon.

 

yea i definately noticed a difference usually when i put 20 bucks in from empty i can barely go 70 miles i hit 105 miles today and put in another 20 bucks i know i need to fill up twice and calcuate both times but i dont have that kind of money

 

Here are various parts store part #'s I came up with:

Autozone: ES70599 (PKG of 4)
NAPA: FPG ES70599 (PKG of 4)
Orielly: 274573 (PKG of 8), 274571 (PKG of 2)

 

Also, be aware that on a single injector it has two part #'s 1 on each side. 1 # is Bosch part #, oterh is Mopar. So dont just look at 1 side of injector and see the part # ending in 739 and move on. That is the one. Rotate it and look at the other side too. YOUR WELCOME!

Bosch PN# 0280155703
Mopar PN# 5277739

 

Question: so I pulled the stock injectors, part # 33007127 on my 92 XJ. (703's in hand ready to swap). Here is a pic with the stock injector on far left, 703 with bakelite type guide installed that snaps over end (that was on it comign out of Struatus 2.4L engine, and far right a 703 with the bakelite guide taken off. Do I use the 703 without that bakelite guide cause if I leave it on it comes nowhere close to getting into the manifld far enough?

 

USE THE CLIPS! You gotta clean out them holes to near perfect and i used seafoam as a lube.

 

I had another tread "703s wont fit".

 

so according to the chart on page 2, i need either ford injectors or bosch injectors for a 99-01, what vehicles specifically can i find those on?