So I just took the front doors off my 2000 and it's got power so I had to cut the wires and make quick connects. I cut the wires took the doors off, drove it a couple times and all the gauges and my radio were fine. But now of all sudden none of my gauges or radio works. The jeep starts and runs fine but nothing from the gauges

 

fuse or ground?

 

All fuses are good. Where would I check grounds at?

 

^this... Sounds like a wire shorted out and blew a fuse. Try a new fuse at #17 and #6. If that doesn't work I think fuse #16 under the hood is the constant 12v.

 

Let's hope this fixes it. Thank you for the info much appreciated.

 

good as in looked at or tested for 12v on both side ?

 

what power options were in doors?

 

Lol... U do know that there are already quick disconnects inside the kick panel right? From the factory?


Sound like u cut 8 wires at once and blew a fuse/relay somewhere... Or.u splice two different wires together...

 

Didn't run a power test only visual check. All the options, windows mirrors and locks

 

.....I didn't know this when I cut them.....I read about other people doing it so I did too....

But it still worked for a little bit after I cut them...

 

replaced ac evap core replaced dash now the gauges dont work display saye no buz any help 2000 cherokee