I have uploaded a picture of my fuse block. The two fuses that are burned dont have any power to them. What should I do to fix this problem? These two fuses control the blower motor as well as the turn signal. Im stuck. Just replaced the entire column trying to fix the blinker problem because the switch was broken, and while i was down there I noticed the burned fuses.

 

Replace the block and trace the electrical problem back to the source to ensure that more damage hasn't been done.

 

Where would be a good place to get a new block. I've looked on ebay and couldnt find it.

 

Today I soldered 2 wires to a fuse and took power from another slot in the block and ran it to the output for the turn signals... works fine. Not a permanent fix, but it works fine...