I did this, this morning and now I only have half throttle response.....? What purpose does this serve if im goin to have no throttle? Can I fix that?

 

You probably did it wrong

 

Yea I didnt pull the throttle all the way back out

 

Another little tip for downshifts. When you start to climb a hill with the torque converter locked and it starts to bog down, rather than giving it a ton of throttle and waiting for it to downshift just barely tap the brake with your other foot and it will unlock the converter. It Just takes about enough to turn the brake lights on. When the computer senses braking it unlocks the converter.

 

Just did this. Verrrry nice!
Had to hold button when going wot.

 

I don't understand how far out it needs to be.. More or less than this?

 

Anyone? My jeep has been shifting worse since I tinkered with it this morning

 

push and hold the button in. while doing this push the cable all the way in. then go wide open throttle then release button.

 

Ok thanks

 

It is all relative to the condition of your cable. Some don't need to be adjusted and some do. I came across instructions on several sites a few weeks ago and there are a few that are listed incorrectly. Some say just push button, push in all the way, release button, then open throttle. That is not correct. The cable does not open to the needed position in that case. Causes the tranny to shift too hard.

You must hold the button the entire time.

steps are push button and hold, push in conduit all the way and continue holding button while you open throttle to full position, then release button.

It is completely correctable though. Just redo it. This should fix your loss in throttle. If you adjust too tight it feels like you can push it to the floor (with some force) and it still won't accelerate to high speeds.

When you get it set just right though it does seem to make a little difference.

 

Much better. Thanks

 

We all know there is some part to this which is done on the tranny itself. It is okay to do just the top end part, but I had problems when I did mine according to the directions given on the thread. I posted earlier about how I got hard shifts and all that so, read the thread and saw that other people on here had the same problem and had to hold the button while going wot, or even hold the button while having someone hold the gas pedal all the way down (what I did-which worked for me).

I understand the basic theory behind the whole thing. You get stretching in the cable over time and have to let that slack out. Here is what I don't get about not holding the button while going WOT.

Please forgive my drawing skills lol.
Pic 1 : This depicts the overall concept.
Pic 2 : X and Y depict possible slack in cable.
Pic 3 : depicts moving in conduit, but doesn't this effectively just move the slack from its current position on further down the cable, closer to the transmission spring? Seems like you are just moving the slack in this step.

Then when you go WOT, my cable never ratchets out without my finger on the button. Seems like if you didn't have the button depressed (which controls the movement of the cable, right???) it doesn't release the excess slack you just moved or created. I guess I am looking at this right. But I do know that holding the button while WOT was a must for me or it made my tranny shift like dunky dooballs.

 

The button on my jeep is so rusted that it won't budge at all...

 

Soak with wd40 or pb blaster then work it a little and I should work.

 

been soaking all day... that D shaped thing is the button. right??