floor pan question
#1
Member
Thread Starter
Join Date: Oct 2009
Location: nc,clemmons
Posts: 219
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: 4.0
floor pan question
i just was replaceing my muffler and i look up there is crazy rust right there no where else is rust well i lift up my back seat and pulled up the carpet right behind the little seperater bar is a hole of rust anyone know where i can just just a floor pan for that side i can ribet it in and then weld need help here yall
#2
Junior Member
Join Date: Aug 2008
Location: Farmington MN
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1989
Model: Cherokee
Engine: 4.0
Yeah, the floor is completely gone on my 89 as well.. I just ripped out the carpet and got a roll of tin and just tech screwed it down the best I could. It's good enough...
#3
I had the same problem. I took a wire wheel and ground down all the rust and cut out the bad spot with a angle grinder, then put por-15 over it then got some galvanized sheet steel and rivited it down seam sealed it. I then put self etching primer over the galavinzed then rhino lined over that. Worked out great
Thread
Thread Starter
Forum
Replies
Last Post
93civEJ1
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
6
10-02-2019 04:08 AM
scoutmstr
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
17
04-06-2016 11:14 AM
MidwestNick
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
10
02-28-2016 02:05 AM
Blackxj51
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
22
09-13-2015 06:06 PM
Sandyman
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
1
09-10-2015 09:21 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)