I got it to like 85% and 15% tuned and Cps reads 5.2 ac volts

 

85%? That's approximately the setting for the square trans connector. What about testing and setting it off the flat 3 wire connector at 17% of input voltage?

 

Yes it was 85 percent on the Foursquare and 15 percent on 3 prong

 

Its your o2 sensor. Mine did the same thing, everytime I would press in the clutch to stop it would die or almost die.

 

It's a new o2

 

Could it be the ignition control module??

 

Percent of what? Which instructions are you using?

 

On the thing you gave it said needs to be 83% of what you first tested and then 17 percent on the other prom connector of what you first tested. When I can get the first 1 was 85 percent of what I first tested and then the second prongconnector was 15 percent

 

Couldn't get 17% of input voltage on the 3-wire connector? What was your input voltage BTW?

 

It was late and we got it close, working again at it thurs.. I can't remember imput

 

Yea my o2 sensors are newish and they went bad

 

I mean we replaced the o2 sensor 2 days ago

 

Needed another new tps and retune it and a new pcm! Now it runs amazing no stutter, no bad idle and no bad hiccup !! Drove a 14 hr. roundtrip and 900 miles no issue!