Directions to get washer bottle out
#1
Seasoned Member
Thread Starter
Join Date: May 2009
Location: Pittsburgh, PA
Posts: 473
Likes: 0
Received 1 Like
on
1 Post
Year: 1990
Model: Comanche (MJ)
Engine: 4.0L
Directions to get washer bottle out
its a 2000 cherokee sport, and the filler is on the driver side. I have searched the site and cant seem to find how to get to the washer bottle(i dont have the jeep on me right now, its getting inspected). I was wondeirng if anyone had a link for this or not or knew an easy way to get to it. It was hit on the fender which must have caused a small crack because we filled it up and a little bit was dripping out it. Im just going to hit up a JY to get the part, i was just wondering if it is a major PITA or not to get to it.
Thanks for any help
Thanks for any help
Last edited by hedbutter; 05-13-2009 at 08:45 AM. Reason: Forgot year
#3
CF Veteran
Join Date: Jan 2009
Location: Northfield MN
Posts: 1,242
Likes: 0
Received 4 Likes
on
4 Posts
Year: 1995
Model: Grand Cherokee
Engine: 5.2 v8
Hey had the same question on my 99 its in between the fender walls on the front drivers side, easiest way to get to it is to take of the black plastic covering inside the wheel well, just pop out all the plastic clips, yank the plastic out, and theres access, oh and as a note, the pumps on the jug, the bottom is for the front window, and the top one is for the rear
as far as yanking out the jug im not totally sure, i think you need to unbolt the filler neck before removal though, but with access to see it you should be able to get a good idea where all the bolts are
as far as yanking out the jug im not totally sure, i think you need to unbolt the filler neck before removal though, but with access to see it you should be able to get a good idea where all the bolts are
#4
Seasoned Member
Thread Starter
Join Date: May 2009
Location: Pittsburgh, PA
Posts: 473
Likes: 0
Received 1 Like
on
1 Post
Year: 1990
Model: Comanche (MJ)
Engine: 4.0L
ok, sweet... like i said, i'll hopefully have it tomorrow and ill look at going through the wheel well.. we might be pulling the fender off completely(it has some damage) but would rather go at it with it on the vehicle so that we dont have to realign, i'll let you know how the washer tank goes tomorrow.
#6
Seasoned Member
Thread Starter
Join Date: May 2009
Location: Pittsburgh, PA
Posts: 473
Likes: 0
Received 1 Like
on
1 Post
Year: 1990
Model: Comanche (MJ)
Engine: 4.0L
Will do, most likely going to go the easy route with it just to get it road ready(i move to erie on monday so i wont have all the tools to tinker on it)
Thread
Thread Starter
Forum
Replies
Last Post
jmsummers2012
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
53
04-30-2021 02:35 PM
toasterknight
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
33
05-21-2016 07:03 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)