Connector Repair, Wire Harness...

I got a 1990 Renix 6 piston motor There is a green three pin connector on the Manifold Presser Sensor. (MPS) one pin on the harness side of that connector is pushed way in. How does one disassemble the connector to repair? are replacement pins available?

thanks!

 

Have as look at this, otherwise you could always replace the connector.

 

Splice one of these in it's place:

​​​​​​
If you're lazy like me, use these:

 

or just splice the dud single one with quality spade or bullet connector... I have done that before