Yeah it still not right. Can't think of anything else that it could be, besides the slave cylinder. Was yours leaking fluid at all? Wet spot between the tranny and bell housing mating area?

 

No wet spot other than the normal rear main seal leak. Im gonna try a different tactic bleeding the system and see if I can get the pedal to come up. Ill post results tomorrow afternoon. If this last attempt at bleeding it dont work, I guess Ill pull the trans again and see if I overlooked something..i.e. backwards clutch disc or bad NEW slave/release bearing.

 

Well, that's a nice silver lining ^. Plus your tools are right there stuck in the wall. I spent a bit last night looking for a pic I had of an (actually pretty neat), hole in the floor right over an exterior slave. I hope bleeding, today works.

 

does yours have the little clip that holds the slave in place?another bleed method depress pedal half way open bleeder depress to floor lock bleeder repeat you should get a strong stream are you?