can someone post a picuture of how your spacers are installed on the front? i got some and they dont seem to go on all the way. thanks

 

give me a min. and ill go look at mine...

 

ok, where the mount point comes down from the body, there are two 1/2 inch or so gasket looking rings and then my 2 inch bb sits flush on them with the springs resting in the groove in the bottom of the bb. make sure its not upside down? or put some weight on it to see if it sits true? good luck! they look nice when done! and sorry no pics...

 

i had to hammer mine onn

 

theres like a little lip i cant get it over. is that normal

 

u have to pull the bump stop off. if you havnt done that already

 

how do i do that?

 

u pull the little rubber thing off and then there should be a bolt all the way in the cup take that out and they will slide right in

 

On my 87 I was told to use a monkey wrench and twist the bump stops off in the front. Maybe the 89 is different. But you might want to be prepared when you go to install them and have a monkey wrench handy.

 

how do i get the little rubber thing off the bottom? my driver side is the only side that has the rubber thing and the "lip". the passenger side is different

 

just **** it off

 

ive been trying to pull it off but it wont come

 

 

figured it out. thanks. my jeep was so covered in mud didnt realize the bump stop was two pieces of metal until i found this pic on another website.
http://www.4x4wire.com/jeep/tech/sus...tfbumpstop.jpg

there in now. tommorrow i start the shackles and fixing leaking oil pan