sarkozi

I have a 2000 jeep Cherokee door pins on the driver side are worn out. I cant get them to pound out. Anyone ever done this before pictures are appreciated. thanks in advance.

troy fritz

Free bump.

zr2toxj

I haven't done mine yet, but have the same problem. I've read that you need to cut the pins with a dremel tool or something similar, then pull the 2 halves out.

Hopefully someone else will chime in who has done this, cause I'd like to know more before I start.

ol"blue

This is on a ZJ but should be similar. >-> http://www.jeepforum.com/forum/f13/d...cement-506080/
Dan

nickl

Did it on my '99 a few weeks back, you must chop the pin with a dremel then punch the 1/2s out. Dorman industries produces a replacement part. Remove the door with a friend its the easiest (& only?) way.

I commented on this thread:

https://www.cherokeeforum.com/f2/wha...-hinges-39943/

Lightfoot

I had to heat up my hinge and used a air hammer to get my pins out.

Try and use just the air hammer, some of my pins came out with just using the air hammer.

nickl

92 might be different, i believe they redesigned them in the late 90s due to door tearing. The pins are flared both ends on later XJs.

viperbabe35

How do u get the new pins in? I got the old ones out, 2000 jeep cherokee classic.