I just bought a flowmaster with a single inlet and two outlets. I was wondering if anyone is out there already with a dual setup that could tell me where to route everything and how they did it. I started looking at where to hang everything when I had my jeep on a lift in shop class the other day but I was questioning where the left pipe will run.


Thanks in advance,
Jon

 

srt6 guy, forget his real username.

Just search jeep SRT6. He is doing a true dual

 

i have the same setup as your post actually asked about on my 93.....

i can snap some pics of it in the next day or so and email them to you showing its routing. PM me your email address.

 

Side pipe it infront of your rear tires

 

i think dual tips out the back, on each side of the jeep looks a little goofy. I would run two pipes next to eachother either out the side in front of the tire, side behind the tire, or straight out the back in the stock location. But its also your jeep, do what you think looks best man.

 

you gotta worry about the driveshaft when you do the sidepipes, ive tried to do that with mine but i couldnt get it to work with the shaft, iv seen a few cherokees around here with duals, i doubt its anybody on here though, it looks to me like they run it over the leaf springs and out right behind the rear tires, i dont know how it runs underneath it though, but im sure youll figure it out, theres alot of room under these things

 

exhaust shop can do this with all the proper hangers and welded joint lot less head aches

 

Are we talkin' dual tail pipes but single exhaust?

 

Perfect! I'll PM you right now