I have a 95 cherokee, 5spd, 4x4, 157k on it. I just replaced the slave cylinder and did some bench bleeding with it. After that it was fine for a bit and then the pedal would start dropping, so i tried bleeding it with the method i saw online (open reservoir, take out rubber piece, close cap, pump pedal). this seemed to stop the pedal drop problem and all seemed fine for a few days.

recently it still has decent pedal but now the clutch engages right off of the floor.

So i tried the bleeding method again and it seemed liek it got better. Are these just air pockets or is my master going out on me?