I just finished my swap from my 92 h.o sport to my 88 limited and i used the stock harness from the 88. I swapped over the intake manifold from the 88 to the h.o motor since the throttle bodies and fuel lines are different and mount differently. I also tried using my 88 dizzy but Im not getting any fire. my main problem is the dizzy plug that meets the harness was crushed in the past so im trying to figure out which wire goes where. My dizzy is getting power and the coil is getting power but im not getting any fire on the spark plug? any ideas? thanks

 

which flywheel/flexplate did you use? they are different, and if you are using the 88 renix injection then you need to use the 88 renix flywheel/flexplate. as for the plug for the distributor, i am sure that someone here can help. i don't have the right diagram for you.

zedpapa

 

Im using the 88 intake manifold, injectors, fuel rail, and transmission, transfer case and flywheel on the h.o. motor.

 

When I did mine I found that it will run but not good with the distributor unplug. Double check all grounds and grounds at sensors, The ground at my knock sensor was broke and I was not geting spark because of it.