30 spline outer shafts?
Thread Starter
Newbie
Joined: Apr 2010
Posts: 22
Likes: 0
From: Hillsboro, Oregon
Year: 1999
Model: Cherokee
Engine: 4.0
30 spline outer shafts?
I am looking to get an OX locker in the front, so I am going to upgrade the axle shafts.
I went to http://www.alloyusa.com/jeep-front-axle-kits.html and looked at some of theirs. This is the reply I got from my brother when I sent him the link "the one i was thinking was 30 inner and stock 27 outer. but the one on there says see notes 1,2, and 3. The notes say that it comes with new 30 spline unit bearings. You might have to call them to verify the correct part number.
Also, you might want to post on a jeep site about going to the 30 spline outers and bearings. See if they think it's worth the money. Those are new to me, and i dont see the reason for them. They are splined into the wheel bearing and held tight with a nut. I'm not sure how they would break, and if the 30 spline bearing goes out, where the "f" are you going to get a replacement one."
Does anyone know which ones would be best. It's a Dana 30. Thanks
I went to http://www.alloyusa.com/jeep-front-axle-kits.html and looked at some of theirs. This is the reply I got from my brother when I sent him the link "the one i was thinking was 30 inner and stock 27 outer. but the one on there says see notes 1,2, and 3. The notes say that it comes with new 30 spline unit bearings. You might have to call them to verify the correct part number.
Also, you might want to post on a jeep site about going to the 30 spline outers and bearings. See if they think it's worth the money. Those are new to me, and i dont see the reason for them. They are splined into the wheel bearing and held tight with a nut. I'm not sure how they would break, and if the 30 spline bearing goes out, where the "f" are you going to get a replacement one."
Does anyone know which ones would be best. It's a Dana 30. Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Eli Brda
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
1
Sep 27, 2015 04:13 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)