When I open the door the locks will go crazy... They will keep clicking.... Then sometimes they will work fine... It is wierd

 

Check the harness where it goes through the doors...well known for fraying and could be causing a short...

 

it does it when I open any door... I fixed the driver door wires in the door jam... It happened after I put LEDs in interior

 

Noggin' pokin' time

Check all the harnesses in the other doors? Other than that, go back and double check your work, make sure you didn't break or fray something, and grounds are nice and clean. I hate electrical, LOL

 

same!!! I have a friend with a Cherokee that complains cause his are not powered Windows and stuff.... I wish mine where not powered haha

 

I would LOVE to find a set of manual doors for mine. Then I could take the ones I have now, and do half doors, LOL

 

not a bad idea... I might just rip the doors off my jeep.... I almost did today driving home from work hearing the clicking of the locks... So I turned the radio up haha

 

I love my manual interior SE but it's a pain reaching over to roll down the passenger window all the time. 2 door power door panels are hard to find though...

 

there are a lot at wellers

 

Mine started going crazy while I was on a six hour trip. Every bump would make the doors lock. It was driving me nuts, so I pulled over and posted here asking for the location of the fuse. CCKen posted a little while later with that info and saved my Jeep from being set on fire on the side of the road.

Maybe someday I'll get around to fixing the wiring, but for now I've just left that fuse uninstalled and gotten used to using the locks manually.

 

lol

 

BTW, that thread is here, in case anybody with a 2000 or 2001 needs the fuse location:

https://www.cherokeeforum.com/f2/pow...k-fuse-219561/

 

I put new panel in passenger door and works perfect... Only $5