1998 Cherokee -5sp. man. trans. clutch cylinder master line.
#1
Member
Thread Starter
Join Date: Aug 2011
Posts: 175
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
1998 Cherokee -5sp. man. trans. clutch cylinder master line.
Hi!~It's been a while. I left the female threaded part on my old inlet line for the hydrolic concentric bearing. So any how it is used to connect the two male lines together. Well both ends of this connector are female ends.
It connects the clutch cyliner master line. What size is it?
Where do I get one now?
It is a BA 10 (5 speed) manual trans. You know the foreign manual trans. in a 1998 Cherokee Laredo.
Also where can you get the rubber boots (dust boot for the shift lever) and stick shift boot (one in the consul), if yours are all tore up?
Thank you!~jretzky
It connects the clutch cyliner master line. What size is it?
Where do I get one now?
It is a BA 10 (5 speed) manual trans. You know the foreign manual trans. in a 1998 Cherokee Laredo.
Also where can you get the rubber boots (dust boot for the shift lever) and stick shift boot (one in the consul), if yours are all tore up?
Thank you!~jretzky
#2
Member
Thread Starter
Join Date: Aug 2011
Posts: 175
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
It is a 1989 Cherokee Laredo-found inlet line fitting.
Hi!~I made a mistake and my car is a 1989 Laredo.
Still can anyone tell me where to find the stock or after market
dust boot for the shift lever and the stick shift boot for the inside of the vehicle?
Thanks!~jretzky
Went to the hardware store for the fitting. It is standard threads, not metric. The line is 1/4 inch and the nut on the threaded male part is 7/16.
The fitting has two female ends to put together two lines. There is a picture on the Jeep Cherokee manual -Chiltons.
Still can anyone tell me where to find the stock or after market
dust boot for the shift lever and the stick shift boot for the inside of the vehicle?
Thanks!~jretzky
Went to the hardware store for the fitting. It is standard threads, not metric. The line is 1/4 inch and the nut on the threaded male part is 7/16.
The fitting has two female ends to put together two lines. There is a picture on the Jeep Cherokee manual -Chiltons.
Thread
Thread Starter
Forum
Replies
Last Post
lpresnell
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
9
08-26-2015 02:34 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)