xtreme velocity

Here is a write up for the Grand Cherokee (ZJ) Threashholds From Howler GT.

Packing was very good I might add!!!



Here are screws provided. Thats alot of wrapping by the way. lol.


Here is everything I need.


Tools Needed:
-Drill
-7/64" drill bit
-Sharpie
-Phillips Screwdriver
-Flat Head Screwdriver
(These are tools I used, Product come with other directions and tools needed)


This is before:
Front

Back


Remove old seal with screw driver just by placeing flathead screwdrive under the seal and pry up in several places.

Repeat for real seal too.

Here is what it looks like after remove of seal:


Clean area while you have it apart(why not, right?)

Repeat for rear seal

Area after cleaned:


Place NEW seal down in place of old one. Mark with sharpie while new seal is down. Mark holes were you will drill your holes.
(Drill holes must be smaller than screws)
Like this:

Repeat for real seal

Now drill only were holes are marked.

Repeat for rear seal

Place NEW seal back in place and screw down with screws provided.
Repeat for rear seal.

Will have finished pictures tmrw. I ran out of daylight and pictures with flashlight are not very good.
I am very very happy about my purchase. These stand out quiet well. They will look dang good with doors off over summer.

P.S. I do not recremend Black&Decker products. lol

__________________
Mine:
94' Grand Cherokee Laredo V8 5.2L Pretty stock
90' Ranger XLT 4.0 V6 2WD 5 Speed
^Back rollin on her 16's again^

Wifes:
04' Grand Am GT 3.4L Customized
00' Grand Am V6 3.4L Stock

xtreme velocity

Finishes Pictures!!!

Passenger Side


Drivers Side


Front Drivers Side up close


Back Drivers Side up close

__________________
Mine:
94' Grand Cherokee Laredo V8 5.2L Pretty stock
90' Ranger XLT 4.0 V6 2WD 5 Speed
^Back rollin on her 16's again^

Wifes:
04' Grand Am GT 3.4L Customized
00' Grand Am V6 3.4L Stock