Jeep Cherokee Forum - Thresholds for ZJ

Here is a write up for the Grand Cherokee (ZJ) Threashholds From Howler GT.

Packing was very good I might add!!!
http://i84.photobucket.com/albums/k1...sh_holds_1.jpg
http://i84.photobucket.com/albums/k1...sh_holds_2.jpg

Here are screws provided. Thats alot of wrapping by the way. lol.
http://i84.photobucket.com/albums/k1...sh_holds_3.jpg

Here is everything I need.
http://i84.photobucket.com/albums/k1...sh_holds_4.jpg

Tools Needed:
-Drill
-7/64" drill bit
-Sharpie
-Phillips Screwdriver
-Flat Head Screwdriver
(These are tools I used, Product come with other directions and tools needed)

This is before:
Front
http://i84.photobucket.com/albums/k1...sh_holds_5.jpg
Back
http://i84.photobucket.com/albums/k1...sh_holds_6.jpg

Remove old seal with screw driver just by placeing flathead screwdrive under the seal and pry up in several places.
http://i84.photobucket.com/albums/k1...sh_holds_7.jpg
Repeat for real seal too.

Here is what it looks like after remove of seal:
http://i84.photobucket.com/albums/k1...sh_holds_8.jpg

Clean area while you have it apart(why not, right?)
http://i84.photobucket.com/albums/k1...h_holds_11.jpg
Repeat for rear seal

Area after cleaned:
http://i84.photobucket.com/albums/k1...h_holds_12.jpg

Place NEW seal down in place of old one. Mark with sharpie while new seal is down. Mark holes were you will drill your holes.
(Drill holes must be smaller than screws)
Like this:
http://i84.photobucket.com/albums/k1...h_holds_14.jpg
Repeat for real seal

Now drill only were holes are marked.
http://i84.photobucket.com/albums/k1...h_holds_13.jpg
Repeat for rear seal

Place NEW seal back in place and screw down with screws provided.
Repeat for rear seal.

Will have finished pictures tmrw. I ran out of daylight and pictures with flashlight are not very good.
I am very very happy about my purchase. These stand out quiet well. They will look dang good with doors off over summer.

P.S. I do not recremend Black&Decker products. lol