Yeah, how far off were ya? lol

Considering the cost of good tires and how fast they can go bad, a good alignment is a drop in the bucket.

 

Final alignment.
Not terrible. Got the caster near dead nuts, but toe in left and right was off a bit. I am glad I took it there, however, as they also went over every nut and bolt I installed, always good to have a second set of eyeballs. Now to put some miles on, come back, re-torque all hardware, and go enjoy it a bit!

There is still more to come...I need to re-install the front DS, and I'll be removing the seats from my niece's Tiburon and putting those in...probably within the next week or so. Then I'm a-gonna take a break from wrenching for a bit...LOL

 

Good stuff. Sounds like when I did my lift, only a couple degrees off on toe. Except they didn't go over each bolt... 800 KM later I found one of my 21 MM wrenches stuck to the frame side of an LCA...

Front drive shaft is good. Did you find any issues with it? I can't rememer anymore. Or scroll up. Lol

 

It's good, just gonna double check what I can while it's out, and paint it...gotta match the rest, right?

 

Why? Mild steel takes like five years to even change colour down there. LOL

 

yay roadworthy!

 

Hells yeah!

Now go stretch her out!

 

Hell yeah man. Glad to see it running.

 

 

YES!

 

Actually get to drive it to work tomorrow! Never been so excited to go to work, LOL

 

Congrats man can't wait to see you post some picks wheeling

 

I can't wait either...Gonna get a few hundred miles on it first, double check everything, then take her out to stretch her legs!

 

Awesome man! ya know we need some pics of it at your work!

 

"Uhp, she lives, HEY DUUUUDE!!!"

Glad you can finally drive her around again man!