Jeep Cherokee Forum
This is a 315 70 17 duratrac just sitting there
This is a 315 70 17 duratrac just sitting there
0 2016/03/03 12:48:25
0 2016/03/04 13:20:48
0 2016/03/09 14:03:10
3.5 inch lift and the tires fit nice. The lift was crap but the tires fit. So I don't care.
3.5 inch lift and the tires fit nice. The lift was crap but the tires fit. So I don't care.
0 2016/03/09 14:03:20
Way cheaper and longer warranty than what I was looking at.
Way cheaper and longer warranty than what I was looking at.
0 2016/03/09 14:03:25
It's a 97 has 22000 power everything and it all works. It needs a heater core and the rear window doesn't open and has a electrical drain. He Also said that the exhaust manifold is bad but I have not looked at that yet. I may keep it or I may sell it once fixed.
It's a 97 has 22000 power everything and it all works. It needs a heater core and the rear window doesn't open and has a electrical drain. He Also said that the exhaust manifold is bad but I have not looked at that yet. I may keep it or I may sell it once fixed.
0 2016/03/13 13:35:43
Leave the doors on, but start with a 2 door.
Leave the doors on, but start with a 2 door.
0 2016/03/13 13:39:34
0 2016/03/16 18:13:02
0 2016/03/16 18:13:27
Didn't go any higher due to not having correct (or any rear bump stops)
Didn't go any higher due to not having correct (or any rear bump stops)
0 2016/03/17 16:06:14
34 1150 17 falken at3w. No low speed lug feel and they are quiet. But my speedo is way off.
34 1150 17 falken at3w. No low speed lug feel and they are quiet. But my speedo is way off.
0 2016/03/17 16:06:21
It is 52x72. 1 inch steel tube, metal grate, jcr gutter mounts and a aluminum wind deflector with a Yakima sticker to look legit.
It is 52x72. 1 inch steel tube, metal grate, jcr gutter mounts and a aluminum wind deflector with a Yakima sticker to look legit.
0 2016/04/04 19:43:16
5.5 front 4.5 back. I like the little bit of lean, but not extreme
5.5 front 4.5 back. I like the little bit of lean, but not extreme
0 2016/04/21 04:51:03
I made it as close to the body as I could get it
I made it as close to the body as I could get it
0 2016/05/27 19:26:01
I removed my fenders and started filling the holes.
I removed my fenders and started filling the holes.
0 2016/05/27 19:26:05
Got a adjustable hitch fro harbor freight and made it longer where is goes in the receiver because this bumper has a boot that you tighten to help the hitch from jumping. With out it it jumps a lot due to hole being a little to big.
Got a adjustable hitch fro harbor freight and made it longer where is goes in the receiver because this bumper has a boot that you tighten to help the hitch from jumping. With out it it jumps a lot due to hole being a little to big.
0 2016/05/27 19:26:08
Made a box to hold a reverse light, trailer hookup and the back up camera.
Made a box to hold a reverse light, trailer hookup and the back up camera.
0 2016/05/27 19:26:12
Finished making the rock sliders. 2 inch tube for the part you see. It is 63 inches long and has 30 degree cuts on the ends and has caps. Rocker tie in is 57 inches long and made from 1 inch angle iron with 8 bolts holding it on.3 mounting legs from 1 inch tube with mounting plates and self tapping bolts.
Finished making the rock sliders. 2 inch tube for the part you see. It is 63 inches long and has 30 degree cuts on the ends and has caps. Rocker tie in is 57 inches long and made from 1 inch angle iron with 8 bolts holding it on.3 mounting legs from 1 inch tube with mounting plates and self tapping bolts.
0 2016/05/27 19:26:20
Bought a different and cheaper mode of transportation.
Bought a different and cheaper mode of transportation.
0 2016/05/27 19:39:44
1.25 wheel spacer 34 11.50 r17 on about 5.5 front lift and 4.5 rear lift
1.25 wheel spacer 34 11.50 r17 on about 5.5 front lift and 4.5 rear lift
0 2016/08/24 04:37:35
here is the latest photo of it. It is as taken apart as it has been in a while.
here is the latest photo of it. It is as taken apart as it has been in a while.
0 2016/08/27 18:10:08
0 2016/09/06 12:57:03
Type r 8
Type r 8
0 2016/09/07 17:34:49
Jl 12
Jl 12
0 2016/09/07 17:35:45
0 2016/09/09 14:26:00
0 2016/09/17 19:21:03
0 2016/09/17 19:21:07
No stance
No stance
0 2016/09/17 19:21:13
They have a good bit more room then the other flares
They have a good bit more room then the other flares
0 2016/09/17 19:21:17
0 2016/09/18 06:22:40
0 2016/09/18 09:00:44
0 2016/09/18 09:01:02
0 2016/09/18 09:01:18
0 2016/09/18 09:01:33
0 2016/09/18 12:55:01
0 2016/09/19 06:02:02
0 2016/09/19 18:09:02
Just checking the tire clearence and seeing what else needs cut.
Just checking the tire clearence and seeing what else needs cut.
0 2016/10/04 08:09:33
Here is all the paint. I went with 2 gallons of main color and a quart of black.
Here is all the paint. I went with 2 gallons of main color and a quart of black.
0 2016/10/04 08:09:55
Doing final sanding and using body filler to fix dents. I am surprised how straight this body is. The only dents on it are the ones I put on it working on it.
Doing final sanding and using body filler to fix dents. I am surprised how straight this body is. The only dents on it are the ones I put on it working on it.
0 2016/10/04 08:10:10