Just another Comanche
CF Veteran
Joined: Oct 2008
Posts: 2,127
Likes: 2
From: Hell, CA
Year: 1989
Model: Cherokee
Engine: 4.0L I6
Nice, One thing I do wish Clayton did was make their frame brackets for 3 holes, not just the stock 2.
I know that they recommend welding to the frame, but still.
Please, install some frame stiffeners. Then weld on the clayton crossmember brackets.
I know that they recommend welding to the frame, but still.
Please, install some frame stiffeners. Then weld on the clayton crossmember brackets.
Thread Starter
Member
Joined: Mar 2011
Posts: 208
Likes: 0
From: Western Maryland, metropolis of Swanton
Year: 2001
Model: Cherokee
Frame plating (stiffening) is on the agenda thanks to the man from "Hell". Just joking. I cut off the upper and lower control arm mounts. I'm not an engineer, but it seemed fairly obvious that quite a bit of structural integrity was sacrificed in the process. I had already planned to stiffen things up a bit. Thanks, I can always use the help. Any suggestions on a supplier?
