I have a 2016 jeep Cherokee, I just installed a HID kit from Xenondepot. the light shine in a "Y" pattern, leaving a big shadow about 10 to 15 feet in the middle of the light pattern. I know how to adjust the lights, but cannot find the adjustment screws. Does anyone know where the adjustment screws are located?

I don't believe the projector lenses have an adjustment. You may need to clock your light bulb. Not sure on the correct alignment but I do know that my kit from xenondepot did not match my factory lightbulbs. The tabs on two of the three were made different. I had to spin it around from the way I thought it was going to go in before it was seated properly.

open the hood, and look straight down over the light area, their is a screw head you will see thats down in a small gear box of sort,in layman terms thats yer crank lol.. i will post a photo later.. its really simple to see requires a longish screw driver, phillips type

Did you post a pic??? I can’t find one & need to adjust my headlights.

This is a 3 year-old thread, that poster hasn’t been back since December 2016. Here is a pic of the adjuster, it is located under the hole in the center of the photo.

Thank you!!!! Mine doesn’t look like that but I think I found it!