Mark this thread as Unsold
[FS] 550 cord grab handle's
Thread Starter
Seasoned Member
Joined: Feb 2013
Posts: 400
Likes: 0
From: North Las Vegas
Year: 2000
Model: Cherokee
Engine: 4.0
I will be going to texas for six months come March and will not be making any till I get back so if any body wants some let me know and I will get them done and shipped in about a week if I have the color you want and if I don't it may take two weeks so I can get the color and make them thanks to everyone who has gotten a set already
Junior Member
Joined: Oct 2013
Posts: 45
Likes: 0
From: Westchester, NY
Year: 1999
Model: Cherokee
Engine: 4.0L Straight 6
Is it possible to put one on the drivers side? There isn't one already there and I don't know where you would screw it into. Has anyone tried putting one on the drives side?
CF Veteran
Joined: Feb 2011
Posts: 1,212
Likes: 1
From: lewisberry PA
Year: 96
Model: Cherokee
Engine: 4.0
for the xj you can just use the screws from the plastic ones yes on the driver side you have to dill two holes in the top plastic panel since they dont have them on that side but there are two holes in the sheet so you would just have to line the holes up and get a self tap screw to fit the hole
Thread Starter
Seasoned Member
Joined: Feb 2013
Posts: 400
Likes: 0
From: North Las Vegas
Year: 2000
Model: Cherokee
Engine: 4.0
Thread Starter
Seasoned Member
Joined: Feb 2013
Posts: 400
Likes: 0
From: North Las Vegas
Year: 2000
Model: Cherokee
Engine: 4.0
yes I have on mine you have to drill a hole in the molding but there should be holes in the metal pre drilled from the factory all I did was put a self tapping screw in them