Serpintine belt keepspulling to the outside.
#1
Newbie
Thread Starter
Join Date: Jan 2011
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
Serpintine belt keepspulling to the outside.
I have a 1996 Jeep Cherokee with a 4.0, the idle pulley bearings went out a while back causing the edge of the bracket the pulley rides on to grind down a little bit. I put the new pulley on the bracket and the pulley looks to be lined up right and straight, yet the belt continues to ride to the outside. Can someone tell me if the bracket is actually causing the problem?
#3
Junior Member
Join Date: Feb 2010
Location: Mesa, Az
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2001
Model: Cherokee
Engine: 4.0 Power Tech
check your harmarnic balancer as well, mine walked the belt enough to get chewed by the fan blade and wrap all around the A/C pully.
#6
Registered Users
Join Date: Feb 2010
Location: New Caney, TX
Posts: 112
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee
Engine: 4.0
Yeah the pulley bracket is probably causing the problem. What I would do is take the pulley back of then using redneck engendering, figure out a way to get a shimmed spacer near the ground down area. Good Luck
Thread
Thread Starter
Forum
Replies
Last Post
cpnwrench
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
13
02-15-2024 08:09 AM
jmsummers2012
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
53
04-30-2021 02:35 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)