Renix HP D30 or Late model HP D30?
#1
Member
Thread Starter
Join Date: Oct 2014
Location: East Bay, CA
Posts: 160
Likes: 0
Received 5 Likes
on
4 Posts
Year: 2000
Model: Cherokee (XJ)
Engine: 4.7L Stroker
Renix HP D30 or Late model HP D30?
Hey guys, I have the opportunity to get an HP D30 for free but it is from an 85. Meaning it has the vacuum disconnect system. Obviously, I would remove all that and swap to a single piece axle shaft.
I was told that the axle would be weaker than a later model HP dana 30, because of the housing. Is there a difference? I have yet to see any info/comparisons from forums.
Thnks!
I was told that the axle would be weaker than a later model HP dana 30, because of the housing. Is there a difference? I have yet to see any info/comparisons from forums.
Thnks!
#2
Senior Member
Join Date: Oct 2011
Location: St. Albert
Posts: 731
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1989
Model: Cherokee
Engine: 4.0L I6
Some people say the vac disco housing is stronger due to the thicker casting in the area, other's say the non-disco axle is stronger. In my experience, they're both similar enough in strength to not worry about it, especially if you're going to a one piece shaft right away. If you plan on trussing it, you might run into more problems with the vac disco housing. Just keep in mind the Renix axles have different brakes/knuckles, so you'll have to address that if you're swapping axles (either swap knuckles, good opportunity to do ball joints, or use renix calipers/pads)
#3
::CF Moderator::
Join Date: Aug 2011
Location: Prescott, Az
Posts: 43,915
Received 1,530 Likes
on
1,241 Posts
Year: 1990
Model: Cherokee (XJ)
Engine: 4.0
What gear ratio is that 85 axle?
Might be 3.73 or 4.10.
TAKE IT!!!!
Might be 3.73 or 4.10.
TAKE IT!!!!