Well after getting a longer rear brake line I thought I might do my e brake while I'm down there. It probably wasn't needed but I doubt I'll be staying at 4.5" for much longer lol.. Its real easy to do and the only thing I discovered is to drill the new holes at least an inch more towards the front then I did, as the unibody is a lot thinner there and one of the holes took me about 20 min to drill

The black paint is where the new holes were drilled, they had to be big enough for the toggle bolt to fit through. The smallest two holes are the original ones


The e brake has a lot of slack coming out of the body so I pulled it as much as I felt comfortable (dont rip it out) and marked those holes


Here's the hardware, 1/4" toggle bolt and a washer... I'm sure someone here has a more official name for it. One this long is not needed, but I already has it lying around the house so it was free I was skeptical at its strength at first but the e brake assembly is very light




Relocated, plenty of slack, I gained about 5 inches

 

Sweet how hard is this to do ?
Also i call those butterfly bolts lol

 

As easy as drilling a couple holes

 

sweet! ill crawl under my jeep and take a look later today!