rear fender cut problem...Really need some advice
#1
Newbie
Thread Starter
Join Date: Feb 2016
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1991
Model: Cherokee
Engine: 4.0
rear fender cut problem...Really need some advice
Hi folks! I've noticed that th po of my 91 xj cut the spot welds along the rear fender well. I sprayed some expanding foam where the sheet metal is separated. But I'm wondering if I need to do something further to regain structural integrity ? Or can I just leave it as is without causing some type of failure in the unibody? Any advice would be greatly appreciated.
#2
CF Veteran
Join Date: Apr 2016
Location: Pasquotank, NC
Posts: 1,679
Likes: 0
Received 15 Likes
on
13 Posts
Year: 1990
Model: Cherokee
Engine: 4.0
Expanding foam is about the worst you can do. The foam will absorb water and hold it against the steel. Will cause it to rust out quick. Can you weld? I would suggest tacking the panels back together, then slather seam sealer on the joint from the inside.