Poor man quick disconnects I need Guidance for hardware needed
#1
Seasoned Member
Thread Starter
Join Date: Mar 2010
Location: Santa Clarita,CA
Posts: 497
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000 Sport
Model: Cherokee
Engine: I6 4.0
Poor man quick disconnects I need Guidance for hardware needed
I am looking and looking, but I cannot find what I want exactly. I have seen the bottom cotter pin style setup what are the best type of setups while still using the stock links for a home brew disconnect.
Could I make a quick disconnect for the top and bottom of the end link ? share you recent attempts and designs of doing this.
Also, is the bottom link bolt pressed in or will it come out nicely.
Could I make a quick disconnect for the top and bottom of the end link ? share you recent attempts and designs of doing this.
Also, is the bottom link bolt pressed in or will it come out nicely.
#2
CF Veteran
Join Date: Jun 2010
Location: Ohio
Posts: 2,117
Likes: 0
Received 3 Likes
on
3 Posts
Year: 1998
Model: Cherokee
Engine: 4.0 stock
The bottom stud is pressed in. You can either press it out or do what I did... Drill it out.
Keep in mind that if your sway bar link breaks during an emergency maneuver it could be a disaster....so build it strong.
Keep in mind that if your sway bar link breaks during an emergency maneuver it could be a disaster....so build it strong.
#3
CF Veteran
Join Date: May 2009
Location: SLC, UT
Posts: 6,328
Likes: 0
Received 1 Like
on
1 Post
Year: 1989 2 door
Model: Cherokee
Engine: 4.0
You don't need a press or drill just hit the lower studs with some PB for a few days then beat them out with a BFH!
As for the budget disconnects use the search for "$7 disconnects"
As for the budget disconnects use the search for "$7 disconnects"
Thread
Thread Starter
Forum
Replies
Last Post
2000CHERO
Modified XJ Cherokee Tech
20
10-12-2015 11:03 PM
rdr8887
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
7
08-24-2015 07:48 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)