Ok I need a little muscle to push these large amounts off rubber im buying a snorkel and headers high flow cat and magnflow muff for some sounds... what would be next for some extra pony's ...is chipping it worth it? Or new injectors... I got a 2 inch throttle body spacer now...

 

dont chip it, waste of money. throttle body spacers also dont do anything either. get a bored Throttle body, that should give you some real gains. headers are good, injectors should benefit as well. just do some searching and you should be able to find which ones you need.

 

If you have not geared it.....then re gear it

 

this as well!

what tire size are you running? what trans? gearing will help you way more than power upgrades. you can only do so much with bolt on parts

 

All I am saying is regear for the change in tire size. The 4.0 is just about all it is stock, you will spend alot to get very little from motor up grades' Change to the 703 injectors, air intake and a good tune up and ea good exhust is about it motor wise. It is all about the gearing.

 

Just do a re gear it's bound to happen sooner or later so why not sooner

 

My truck does not have a stock tranny or rear axle... idk what the tranny is cuz the guy lost the paper work but it don't match my markings on my gear selecter cuz it has a extra one.. a two wheel low granny gear and I have a full blown posy in the rear its looks alot thinner but diff is bigger... im running 34 14:5 r 15 with between a 8 to 10 inch off set rim

 

You should figure out what your working with before trying to move further ahead.

 

There's no numbers or id tags on anything

 

No casting marks of any kind anywhere?

Seems hard to believe.

Maybe get some pics and post them here for ID.

 

take a picture of the rear axle and transfercase

 

These aether only numbers on it

 

D35

 

Someone locked a D35?

 

if its not a stock axle, according to OP, that means someone swapped in a d35???

OP, what size tires are you running?