Front to rear drive shaft
So I'm planning on putting in an sye, and after some research I've learned that you can use a stock front drive shaft for the new rear shaft. when doing this, are there any modifications that must be made to the shaft? Or is it a direct fit?
CF Veteran
Joined: Mar 2010
Posts: 47,923
Likes: 38
From: Broward County Fl.
Year: 1989 xj sport 2dr
Model: Cherokee
Engine: 12 hole bosch Injectors
Gotta measure what length you need. Numerous different lengths according to lift in jeep. http://www.myjeepxj.com/useful-infor...aft-infomation
CF Veteran
Joined: Oct 2013
Posts: 5,924
Likes: 203
From: Greenville, SC
Year: 1999
Model: Cherokee(XJ)
Engine: 4.0
Originally Posted by shadowmoses
So I'm planning on putting in an sye, and after some research I've learned that you can use a stock front drive shaft for the new rear shaft. when doing this, are there any modifications that must be made to the shaft? Or is it a direct fit?
CF Veteran
Joined: Jan 2015
Posts: 1,381
Likes: 3
From: Southern Maryland
Year: 1991
Model: Cherokee
Engine: 1999 4.0L
lots of factors, such as type of engine and transmission, type of SYE, type of rear axle, amount of lift, etc. On my 4.0 AW4 with a hack and tap SYE and and 8.25 axle and about 5" of lift, I am barely able to use a matching front driveshaft. With a regular SYE the driveshaft would be too short and I would need to use a ZJ or WJ shaft.
lots of factors, such as type of engine and transmission, type of SYE, type of rear axle, amount of lift, etc. On my 4.0 AW4 with a hack and tap SYE and and 8.25 axle and about 5" of lift, I am barely able to use a matching front driveshaft. With a regular SYE the driveshaft would be too short and I would need to use a ZJ or WJ shaft.
CF Veteran
Joined: Oct 2013
Posts: 5,924
Likes: 203
From: Greenville, SC
Year: 1999
Model: Cherokee(XJ)
Engine: 4.0
Originally Posted by shadowmoses
3 inch rough country lift until I add spacers and shackles to net about 5 inches of lift
Trending Topics
CF Veteran
Joined: Oct 2013
Posts: 5,924
Likes: 203
From: Greenville, SC
Year: 1999
Model: Cherokee(XJ)
Engine: 4.0
Originally Posted by shadowmoses
well it's I6 2000 Cherokee, np231 with a d35 rear (sadly)
CF Veteran
Joined: Jul 2013
Posts: 7,554
Likes: 17
From: Monett, MO.
Year: 1999
Model: Cherokee
Engine: 4.0
I checked out buying another front shaft and then rebuilding it with new larger joints and by the time it was finished it was so close to a new one from a vendor on eBay custom made for an XJ Dave's Driveshaft $199 I just bought it instead.



