Alright so I've gotten this far, and now I'm stuck. I cut the leaf spring bolt, and now about 3/4 inch of it, is stuck inside the "frame rail". Its in the welded nut, and I've tried everything. I tried drilling it out, broke my bits. I tried heating it up and busting the nut loose. It's stopping me from finishing my lift :/ any ideas on how to get this little piece out?

 

Nobody?

 

keep at it with another drill bit.

 

can you get at the pc sticking out the back side of the nut and finish screwing it thru the nut with vise grips or small pipe wrench ? was any pb blast used ?

 

i can see the bit catching there, just need to go deeeeper. and use lubricant, die cutting oil works.

 

if you broke the nut off in side cut out that pirce where it sits clean it up weld on a new nut and weld it back in and dont forget the never seize

 

Not sure how the nut is attached inside (Mines nut broke off on inside) but if you end up having too take out the nut try to use an air chissel to cut/ knock it out. Good luck