hey guys so i just redid my exhaust. Got a new cat and muffler. I want to run it with no tailpipe. So i want to dump it right after the muffler, but the only problem is that my exhaust hangs half way down to the ground now. Is there anyway i can pin it up so it won't hang down so far?

 

Why don't you want to run a tail pipe? There are hangars on the tail pipe so it won't hang so low.

 

I can not think of a benefit from not running a tail pipe.

 

? Run a tail pipe, keep the exhaust fumes out of your cab. And you can buy exhaust hangers that hold you exhaust up at advanced or auto zone.

 

That's because there is none

 

my exhaust hits my leaf springs so i was just going to get a 90 degree pipe and dump it out the side.

 

Well thats still considered a tail pipe, get a 90' and have it come out in font o the passenger rear tire. Like I said before you can buy hangers

 

i also deleted my pipe after my muffler and did the 90 degree turn to the passenger side, i just cut the tail pipe hanger and re welded it up where i needed it to add support

 

is there a way to do it without welding. I do not own a welder.

 

Yes, there are hangars that clamp to the pipe with a muffler clamp.

 

is this something they sell at auto zone or are they special order.

 

U wont pass inspection with that

 

if you don't own a welder than do what the other member said, and they are regular off the shelf item by the exhaust pieces usually.

 

That depends on the state.

 

Advance Auto, Autozone, and Napa all carry exhaust hangars.