I recently decided i wanted to take the doors off my 91 jeep cherokee. So i looked at it and i cant figure out how thw wiring is donw on the front and rear. Id like to be able to take the doors off in matters of minutes. the rear doesnt seem to have a "plug" to disconnect and the wires in the front arent long enough to pull thru so if it stays the way it is that means i have to unscrew the panel everytime i want to take off my doors?

any suggestions on how to go about my dor removal or any pictures of yalls door removals?

 

Im wondering this too. Summer is coming soon anwant to be able to chill around town anon the trails. Might even see about building tube doors

 

On the ones I couldn't get to the plug, I just cut them and got a lil connector and hooked it up.

 

i leave my kicker panels off

 

I use a trailer plug:



altho then again I only have component speakers and the rest is manual

 

Do you guys put the doors back on at any time? i got my drivers side off and realized what a pain it was to put back on and have been scared to take it off again. any pointers???

 

cut little angles into the pins. keep the bottom pin long and cut the top pin in half. it makes installing alot easier

 

This makes the top pins prone to break. Just happened to me yesterday. Careful.

 

depends on how much you cut. i remove/instal mine often. no issues and i have heavy 2 door-doors

 

True. PO decided to hack the entire top stud off.....