Door alighnment problems after hinge cut
#1
Newbie
Thread Starter
Join Date: Jan 2015
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
Door alighnment problems after hinge cut
I have 94 cherokee and I have cut the lower portion of the hinges to allow me to remove them. But when I put them back on the front passenger door catches the quarter panal. I can get it shut by lifting and moving it around but the lower half of the door is pushed out about an inch. Only thing I can think of is the weld poped on the body hinge or bent? Any thoughts and suggestions on how to fix it or what it might be will be appreciate. I will put pictures up tomorrow morning. Thank you
#2
Member
Join Date: Aug 2012
Location: New Hampshire
Posts: 105
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2001
Model: Cherokee
Engine: 4.0
It's probably bent or the welds cracked, my 01 needs both the drivers and passenger front doors realigned. I'm holding off until I install a set of notch custom high clearance fender flares.
Also check the holes that the pins go in if there all walled out then that will be an issue too.
Good luck
Also check the holes that the pins go in if there all walled out then that will be an issue too.
Good luck
Thread
Thread Starter
Forum
Replies
Last Post
Rotorhead
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
20
09-23-2023 04:17 PM
hpwrestler220
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
4
08-31-2015 11:32 AM
mboudreau001
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
2
08-26-2015 04:37 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)