DIY quick release idea brainstorm...
#1
Junior Member
Thread Starter
DIY quick release idea brainstorm...
Inspired by the other forum's diy quick release using Heim Joints, I wonder if this would work...
I am going to order two of those ball Joint end, screw it on top of the stock sway bar link, get one of those I_I shape channel that is 1 inch wide and 1.5 inch tall, cut it about 1 inch length mount it upside down under the swaybar, and link it with a quick release pin.
$53.80 with bigger(overkill) joint and much less parts, What do you think?
I am going to order two of those ball Joint end, screw it on top of the stock sway bar link, get one of those I_I shape channel that is 1 inch wide and 1.5 inch tall, cut it about 1 inch length mount it upside down under the swaybar, and link it with a quick release pin.
$53.80 with bigger(overkill) joint and much less parts, What do you think?
Thread
Thread Starter
Forum
Replies
Last Post
xjwolfman
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
8
08-26-2020 12:59 PM
NM-XJ
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
18
10-23-2018 04:21 PM
LittleRed94
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
09-05-2015 08:56 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)