Control Arms
#1
Junior Member
Thread Starter
Join Date: Jun 2012
Location: Oregon
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1991
Model: Cherokee
Control Arms
I just got a set of procomp lower control arms and have some issues.
In the bracket connoted to the frame the was a spacer bracket holding the stock arms in, when i tried to put the new arms in it would not fit so i took it out and it seemed to fit however now the arm does not fit into the axle bracket, it is too wide. did i buy the wrong arm or am i doing something wrong? thanks
In the bracket connoted to the frame the was a spacer bracket holding the stock arms in, when i tried to put the new arms in it would not fit so i took it out and it seemed to fit however now the arm does not fit into the axle bracket, it is too wide. did i buy the wrong arm or am i doing something wrong? thanks
#2
THE Admin
Join Date: Sep 2010
Location: Lantana, Fl
Posts: 34,036
Received 231 Likes
on
187 Posts
Year: 1996
Model: Cherokee (XJ)
Engine: 4.Slow
That spacer you removed is for adjusting your caster. You can run without it but it may knock your alignment out if you wheel regularly. And Welcome to the forum.
#3
Junior Member
Thread Starter
Join Date: Jun 2012
Location: Oregon
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1991
Model: Cherokee
Thread
Thread Starter
Forum
Replies
Last Post
cpnwrench
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
14
Today 12:21 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)