I'm swapping to a full cluster in the '86 Comanche. I have a '90 Cherokee full cluster to swap in. I know the speedometer cables are different and have the one from the '90 and the odometer is changed to the correct mileage. All the connectors look the same but just wanted to make sure it will plug right in without any issues.

The other question. I've swapped in a Chevy 350 into this Jeep so the wiring is all different at the engine bay. I've traced down the wires to the tach being the green w/white wire going into the original 2.8L coil from wiring diagrams (goes from pink from the distributor to the coil then green w/white to the cluster). Anyone by chance know which wire this connects into to get a tach on a Chevy 350?

EDIT: Wrong section, sorry, too many tabs open. If a Mod can move it, I'd be much appreciative.

 

You might get more responses in the tech section.

 

I caught the mistake a few minutes after I posted it but couldn't find the delete key.

 

Haha I've done the same thing! But I don't think there is one. I think only the mods can delete it. Good luck with your swap!