Bend the upper link and the Clayton kit should work? XJ88 built his at 4.5"

Would buying radius arms And modifying it into a 3 link work?

Would be a waste. Wouldn't be able to reuse the uppers

Yeah I was thinking out loud. I tried checking ballistic fab but didn't find anything

They don't have a kit, but I can give you a list of what to buy

Sound good. Thanks

Want to make your own crossmember?

What joints do you want to use?

Round or square tube?

I used square tubing. A lot cheaper than dom. Also used ballistic 2.63 rebuildable joints on each end

So u use 6 in total?

Johnny joints on one end for sure, I haven't decided about other end.

I work at a machine shop so DOM tubing access is no problem, so I would go down that route.

I want to build my own crossmember but I have no time. I work 730-4 then 6-10 everyday

Ya, but you can just use solid bushings on 1 end. I wanted it to have no binding at full flex

I can't remember if I asked, but how much did u pay for all six ends?

IIRC $40 ish per joint. Ballistic always has a 10-20% off sale going on also. Thier weld-in threaded inserts are cheaper than anywhere I seen at the time also. I have no complaints about anything I bought from them.

So the joints don't include the inserts? I ll have to buy them separately?

no the inserts are not included, but I think there were $10 apiece. heres a link to my build page on their forum http://forum.ballisticfabrication.co...c.php?f=22&t=5