GearGrabbinXJ

Hello everyone, I'm relatively new to this forum but I'm looking for a way to cheaply MAKE some sway bar quick disconnects. Has anyone done this before, or know of someone who has? I recently. Broke on so I replaced both but if I plan on lifting it I or even if I don't quick disconnects would be a wise upgrade, Thanks, Shane.

98cherokee531

if you could find a way to get the top to hinge, you could put a bolt in the bottom and drill a hole thru the bolt. slide your link on and put a pin to hold it on

The_ocho

Link to home made discos.

Follow the instructions in the link. all the stuff can be bough at your local home improvement store. don't forget to pick up some bungie cords to hold the sway bar up when you have it disconnected. Iv ran these for a few months before switching over to JKS

john deer green

theres a post on the first page of the homebrewd jeep mods in the fab section that has the homemade discos and the bracket he made to hold the sway bar up its a realy good idea instead of using bungees witch work to

GearGrabbinXJ

I'll check that out thanks guys!